Just click OKĦth step: click "Apply" on the left upper corner. A window will pop-up telling you that setting the partition to Active will make other primary partitions inactive. Use all the available space so that "Unallocated space before" and "Unallocated space after" say 0.0 MB, and then click OK (AGAIN, assuming it's an USB Flash Drive up to 32gb)ĥth step: Right-click your USB drive, click "Advanced", then select "Set Active". No need to worry, just click OK.Ĥth step: A new pop-up will be presented, where you can set size and position. Note that the cluster size option will disappear after you select Fat32 as file system.
I randomly selected N:, now whenever I plug my USB drive it is show as GC(N
Drive Letter: You're free to select it too.
Create as: You must be 140% sure it's set to Primary Partition Label: You're free to label it whatever you want. Right-click it and select "Create Partition" NOTE: follow everything exactly as stated here, so you won't end up screwing your USB device againġst step: open up EaseUS Partition Master Free Edition and select Partition ManagerĢnd step: your USB drive will be listed at the bottom of the program, and will be shown as Unallocated. When it happens you can close CMD EaseUS Steps: It's not really necessary, but after DISKPART finishes it's job (which, by the way, may take some time), a new line will appear with what you've written in the end. "Wait a minute, why can't I just use the 'clean all' command?" I tried and it just gave me an "Access denied" error, but you're free to try itĦth step (OPTIONAL): If you've never used CMD before, wait about 3 seconds after hitting anter for the "clean all" command and type anything (your name will do) BUT DON'T hit enter. pay CLOSE attention on this step so you won't select the wrong drive NOTE: it's quite obvious, but on CMD you must type the commands without quotes, and hit enter to actually use itġst step: start CMD as administrator, use the "DISKPART" commandģrd step: check the number that representes your USB drive, type "select disk X" (where X is your drive number) and hit enter. So read on This tutorial will (most likely) help you with the following problems: If it changes the partition, it's integrity is screwed up. If you’re lucky, the installation was successful and you can start playing SD Remix. Then the screen will black out for 5 or so seconds at most. Go to the game/install partition and press A. The Wii should go to a Gamecube logo screen with DIOS MIOS printed underneath the logo or something similar and the disc drive should make a noise like it just accepted a disc. If it isn't listed, go to "Hard Drive Settings" on USB Loader. If it takes longer than it should to boot, it's a sign of bad formatted USB stickĤ- Last check: if your game is listed, try to run it. You must have a GC game installed to check itģ- Start USB Loader GX. To do so, follow these steps:ġ- Disable multi-USB port support on USB Loader GX, if it isn't alreadyĢ- Plug your "suspicious" USB Drive on the USB port 0 (Closer to the edge of the console). If it isn't listed at all, you can at least try. If it's listed as compatible, check if it's really having problems. Also, you need to check if your USB Drive is compatible with Wii.
Attempting to install any other cIOS on a Wii mini won’t work. If you have a Wii mini, install this cIOS instead. Attempting to install any other cIOS on vWii won’t work. If you have a Wii U (vWii), follow this guide to install cIOS instead.
Some homebrew might work better using cIOS. This is required if you want to load games with a USB Loader.
This tutorial will tell you how to install cIOS (custom IOS). For support in English, ask for help at RiiConnect24 on Discord.